Silvergate Manufacturing
9755 Birch Canyon Place Suite 200
San Diego, CA 92126
Phone (858) 444-8280
info@silvergatemanufacturing.com
RailClamps for lift out bridges
QuickSearch for the Perfect RailClamp
Bridge Hinge
Bridge Hinge Kit
Part: BHK
Code: Code 332

Made out of 1/4 x 2 inches BRASS and is 8 inches long. Rated to hold up to 30 pounds. Comes complete and ready to install with a pair of Bridge RailClamps (332-01OT) and 4 Power RailClamps (332-015)

 Installation:
  • Mount the hinges to the bridge abutment, mount to hinge plate.

  • Drills holes as necessary to fit your bridge.
Bridge Hinge
Part: BH
Code: Any size rail

Made out of 1/4 x 2 inches BRASS and is 8 inches long. Rated to hold up to 30 pounds.

Installation:
  • Mount the hinges to the bridge abutment, mount to hinge plate.

  • Drills holes as necessary to fit your bridge.

  • Mount the 332-01OT to the end of the rails, mount Power RailClamps for jumper at the hinge end of the bridge.

Code 332

LiftOut Bridge RailClamp
Part: 332-01OT for code 332 rail
Code: Size 332

Half open top RailClamp mode out of BRASS with Stainless Steel Allen-Head Screws. Used for lift out bridges, hinged brides, or any lift-out application. One side has a ball plunger screw that snaps the rail in place. You can use two pair and lift out a bridge that you might NOT want to leave outside.

Installation:
  • Make sure the track is laid square and straight with each other.

  • Install Lift Out RailClamps, fit bridge in place, it is advisable to fasten the track in place so that it doesn't move when the bridge is out.

  • You don't need to adjust the little ball plunger screw on the side, the one that makes it "snap" into place, it is set.

Code 250

LiftOut Bridge RailClamp
Part:250-01OT for code 250 rail
Code: Size 250

Half open top RailClamp mode out of BRASS with Stainless Steel Allen-Head Screws. Used for lift out bridges, hinged brides, or any lift-out application. One side has a ball plunger screw that snaps the rail in place. You can use two pair and lift out a bridge that you might NOT want to leave outside.

Installation:
  • Make sure the track is laid square and straight with each other.

  • Install Lift Out RailClamps, fit bridge in place, it is advisable to fasten the track in place so that it doesn't move when the bridge is out.

  • You don't need to adjust the little ball plunger screw on the side, the one that makes it "snap" into place, it is set.
Silvergate Manufacturing
9755 Birch Canyon Place
Suite 200
San Diego, CA  92126
Phone (858) 444-8280
info@silvergatemanufacturing.com
Silvergate Manufacturing, Inc.© Copyright 2009 All rights reserved.

[an error occurred while processing this directive]